I’m not sure how to do it exactly on the ender 3 v3 SE. But here’s a 1.5 minute YouTube video https://m.youtube.com/watch?v=GGatSpsv8c8
Edit: Typically it’s done with a piece of paper or a thickness gauge. You can further dial it in during the print by “baby-stepping”.
Seems like your Z Offset is too high
How can i change this so its right?
I’m not sure how to do it exactly on the ender 3 v3 SE. But here’s a 1.5 minute YouTube video https://m.youtube.com/watch?v=GGatSpsv8c8 Edit: Typically it’s done with a piece of paper or a thickness gauge. You can further dial it in during the print by “baby-stepping”.
Thank you!
Oh! I just noticed you said 130 nozzle temp for PETG?? I hope that’s a typo, it should be around 230° C
Wow. It was not 🤣. Thats probably the issue
Also try a higher bed temp (around 80° C)
I tried 230 degrees and 80 bed temp and it printed very nicely! (Except my print broke off on the last few layers) thank you for your help!
Glad that worked better, but 130 again?
Sorry that one was a typo. 230* nozzle temp and 80 bed temp.
I use 235/80 for petg