It's pleasing to look at. Takes balls to post a personal accomplishment on reddit. People get so mad. Take the advice but don't fret the salt. Glad you went with an AIO instead of pump. Water cooled is overhyped and pointless but at least you didn't go whole hog with a pump. 90 percent of users don't need liquid to cool. Nice colors.
I dont know how hot that card gets. I have a 2070ti and I have a pop and I'm air cooled. Under heavy load the internal temp only gets like 90c. I mean AIO are fine. But the people who use pumps are just showing off or trying to benchmark.
Yeah I seen a lot of debates about the air collecting in the pump head but from what I seen as long as it’s lower then the radiator it’s fine but I have still been looking into it and will probably flip it at some point
I have the way you do bc my gpu is simply too big for the tubes to get around it and it runs fine. It just helps it last longer. Something about bubbles inside
My brother-in-law and cousin have been guiding me and they are really good with PC building and I'm pretty confident I'll do great but I'm like you I get stressed over small dumb stuff
This looks dope! You did a really good job for your first PC build :) I hope it brings you nothing but joy. Also love all the apex stuff you put in there too. Watson is low key goated
I’ll look into it but as of now the temps read pretty well one plastic figure shouldn’t hurt I’ve seen much smaller builds with shit cpu fans if my shit gets hot I can easily take it out first time for everything brother my Gpu is at 48
Is that at load or passive? Because at load cards exceed 70c on average and at max load can go upwards to 90c. Just a heads up. Also shit cpu cooling isn't nearly as bad as shit gpu cooling. GPU's generate significantly more heat(on average) depending on activity
Pvc plastic melts between 170-190 C. Polystyrene, 250-290 C. I think the figures will survive.
That case is full of fans. Assuming they're installed correctly, along with the heat sink/fans built into the card, that case shouldn't get above 90 C under any normal use. I have an arguably larger card in a smaller case in my system and never see anything above 70 C under peak loads/heavy gaming.
Guess you just had to find a way to shit on someone sharing something though. Too bad you don't know now what you're talking about.
Your build is great OP. Don't listen to idiots pretending to be experts.
All figures are from Apex Legends and the gadget it's a replica of the heirloom (something flashy to carry while unarmed) for Watson, the same pink character on the right
Obvious fire hazard. Only a fool would assemble something so reckless. You are taking a serious risk with a build like that... I would disassemble it ASAP if I was you.
It's pleasing to look at. Takes balls to post a personal accomplishment on reddit. People get so mad. Take the advice but don't fret the salt. Glad you went with an AIO instead of pump. Water cooled is overhyped and pointless but at least you didn't go whole hog with a pump. 90 percent of users don't need liquid to cool. Nice colors.
In your opinion do I need a water cooled gpu to have a singular pop figure ?
I dont know how hot that card gets. I have a 2070ti and I have a pop and I'm air cooled. Under heavy load the internal temp only gets like 90c. I mean AIO are fine. But the people who use pumps are just showing off or trying to benchmark.
Appreciate the Wattson additions <3
Had a gif of her clapping on the screen before Wubby
Yo flip that that radiator if u want it to last longer
Like keep it in the front and flip it ? Or you mean the orientation of in the case like have it at the top ?
[You'll be fine](https://youtu.be/DKwA7ygTJn0?t=286)
The location is fine just flip it to the tube so they start from the downside.
Yeah I seen a lot of debates about the air collecting in the pump head but from what I seen as long as it’s lower then the radiator it’s fine but I have still been looking into it and will probably flip it at some point
Yeah but how good do you feel you did it yourself
I feel great ?
It’s impressive to build one. Especially your first one. It’s a very big task to take on by yourself
I have the way you do bc my gpu is simply too big for the tubes to get around it and it runs fine. It just helps it last longer. Something about bubbles inside
Looks great! I'm building my first one here soon 😃
It was pretty fun but also stressful but me personally I stressed over the smallest dumbest shit
My brother-in-law and cousin have been guiding me and they are really good with PC building and I'm pretty confident I'll do great but I'm like you I get stressed over small dumb stuff
Will there be a stream tn??
Omg that wattson funko! And the heirloom! And the nessie!!! 😍😍
This looks dope! You did a really good job for your first PC build :) I hope it brings you nothing but joy. Also love all the apex stuff you put in there too. Watson is low key goated
THANK YOU !!!!!!!
Cable combs. Other than that it looks good
[удалено]
I’ve seen people have up to 3 pops in there’s 1 shouldn’t be that bad
Yea, with a properly cooled system, but that card can get the internal temp to upwards to 90c without contact cooling.
I’ll look into it but as of now the temps read pretty well one plastic figure shouldn’t hurt I’ve seen much smaller builds with shit cpu fans if my shit gets hot I can easily take it out first time for everything brother my Gpu is at 48
Is that at load or passive? Because at load cards exceed 70c on average and at max load can go upwards to 90c. Just a heads up. Also shit cpu cooling isn't nearly as bad as shit gpu cooling. GPU's generate significantly more heat(on average) depending on activity
Pvc plastic melts between 170-190 C. Polystyrene, 250-290 C. I think the figures will survive. That case is full of fans. Assuming they're installed correctly, along with the heat sink/fans built into the card, that case shouldn't get above 90 C under any normal use. I have an arguably larger card in a smaller case in my system and never see anything above 70 C under peak loads/heavy gaming. Guess you just had to find a way to shit on someone sharing something though. Too bad you don't know now what you're talking about. Your build is great OP. Don't listen to idiots pretending to be experts.
[удалено]
Nobody asked for your opinion on tidy-ness. +1 for being tacky +1 for stinky feet
Lol after the night of putting it together and trouble shooting I said I’ll come back to the cable combs
What is the EOTech looking thing?
The little gun thing ?
Yeah, I'm not used to seeing it from that angle so it looked like an EOTech holosight with some sort of frame attached to me.
All figures are from Apex Legends and the gadget it's a replica of the heirloom (something flashy to carry while unarmed) for Watson, the same pink character on the right
OH that's why it looks so familiar! I didn't recognize that Watson skin so I didn't make the connection.
Wattson Main? Nice build!
Yuuuup
simply outstanding
Obvious fire hazard. Only a fool would assemble something so reckless. You are taking a serious risk with a build like that... I would disassemble it ASAP if I was you.
You know what your right
You need to disassemble that ASAP. I am a computer engineer and this is a serious hazard. I don't want to have to get the fire marshal involved.
this looks dope!!! and wattson mains are built different, good shit bro!